硫酸溶液中Ag+离子对Mn2+离子阳极氧化的催化作用

Anodic oxidation of Mn2+ and Ag+ ions and anodic oxidation of Mn2+ ion on platinum electrode in H2SO4 solution catalyzed by Ag+ ion are studied by using RRDE and triangle voltammetry techniques. Mn2+ ion is oxidized on the anode surface with adsorped OH group to form a certain compound containing Mn3+, which causes Mn2+difficult to be oxidized directly on anode. Near the potential of oxygen evolution from H2O decomposition, Ag+ ion is oxidized to form Ag2+ ion. This is the main reaction on anode because of its reversability. At higher potential silver oxide is formed on the anode. The oxide catalyzes the decomposition of H2O strongly. The anodic oxidation of Mn2+ion catalyzed by Ag+ takes place and Ag2+ ion and silver oxide are no longer the product of Ag+ anodic oxidation when Mn2+ exists in solution at the potential for Ag+ anodic oxidation. It is confirmed that the catalysis reaction is homogeneous and very fast.     

The Electrochemical Detection of Arsenic(III) at a Silver Electrode

A study of three electrode substrates namely gold, platinum and silver, for arsenic detection via anodic stripping voltammetry is reported. Hitherto it has been accepted that gold is the most suitable metallic surface for use in this context, as suggested by Forsberg and co‐workers (Forsberg, G.; O'Laughlin, J. W.; Megargle, R. G. Anal. Chem. 1975, 47, 1586.). We revisit these experiments and find that by switching from hydrochloric acid to nitric acid the oxidation of silver that had previously masked the arsenic stripping signal at this surface is shifted considerably enough to allow a clear, analytically reliable As(III) stripping signal to be detected. In contrast to silver and gold platinum is found to have poor performance as an electrode substrate for arsenic detection. Using ASV a LOD of 6.3×10^?7 M is found for As(III) detection at a silver electrode, similar to that which we have previously reported at a gold electrode (A. O. Simm, C. E. Banks and R. G. Compton. Electroanalysis, 2005, 17, 335.) The use of ultrasound was then investigated to further reduce the LOD, which was found to be 1.4×10^?8 M. Apart from reduced cost of silver it also has an added advantage over gold in that it has a higher hydrogen reduction overvoltage enabling a 100 mV more negative deposition potential to be used before the onset of hydrogen evolution when compared to a gold electrode.     

Iridium Anodic Oxidation to Ir(III) and Ir(IV) Hydrous Oxides

Iridium oxide films (IROFs) are known to have an enhanced or the so‐called super‐Nernstian (<59 mV/pH) pH‐sensitivity. The intention in the present study was to find out the reasons of such behavior and also to elucidate the nature of iridium anodic oxidation processes. The methods employed were combined cyclic voltammetry and chronopotentiometry. Iridium layers of 0.1 to 0.2 μm thickness, deposited thermally on titanium or gold‐plated titanium substrates, were used for investigations. IROFs on the surface of working electrodes were formed anodically by applying a constant potential in deaerated and oxygen‐containing solutions of 0.5 M H₂SO₄, 0.1 M KOH and 0.5 M H₃PO₄+KOH. Linear pH‐dependences of the stationary open‐circuit potential with the slopes close to 59 mV/pH were found for iridium electrode oxidized at 0.4 V–0.8 V (RHE) in deaerated and at 0.8 V–1.2 V (RHE) in O₂‐containing solutions. They were attributed to reversible Ir/Ir(OH)₃ and Ir/ IrO₂?nH₂O metal‐oxide electrodes, respectively. It has been suggested that the main current peaks seen in the voltammograms of iridium electrode in acid and alkaline solutions are of different nature. The difference between iridium electrode surface states in acid and alkaline solutions has been presumed to be the main reason of super‐Nernstian pH‐sensitivity of the IROFs. On the basis of the results obtained standard potential of Ir/Ir(OH)₃ electrode and the solubility product of Ir(OH)₃ have been evaluated: =0.78±0.02 V and K_sp=3.3×10^?64.     

脱乙酰壳多糖化学修饰电极测定铂的研究

用脱乙酰壳多糖修饰电极为工作电极，阳极溶出伏安法测定痕量铂。在ｐＨ＝２￣３的ＫＣｌ－ＨＣｌ底液中，－０．３Ｖ富集２ｍｉｎ，静止１５ｓ，以０．２Ｖ／ｓ扫速阳极溶出，峰电位在－０．１６Ｖ（ｖｓ．ＳＣＥ），铂（Ⅳ）离子浓度在０．５￣５．０μｇ／ｍＬ范围内与峰高呈线性关系。富集１０ｍｉｎ后，可检测０．０２５μｇ／ｍＬ铂（Ⅳ）。该法用于贵金属矿样的测定，无需分离，结果满意。用循环伏安法、紫外光谱和拉曼光谱研     

羟乙芦丁在玻碳电极上的阳极微分脉冲伏安法测定

本文对羟乙芦丁在玻碳电极上的阳极微分脉冲安行为进行了研究，发现在Ｎａ２ＨＰＯ４溶液中（ｐＨ＝８．９５）于＋０．６４Ｖ（ｖｓ．Ａｇ／ＡｇＣｌ）左右产生一个良好的阳极氧化伏安峰，浓度在５～６０ｍｇ／Ｌ之间与峰电流呈线性关系，不需分离直接测定了片剂中的羟乙芦丁含量。电极反应为扩散速率控制的不可逆可程。     

POROUS MEMBRANE TEMPLATED SYNTHESIS OF POLYMER PILLARED LAYER

The anodic porous alumina membranes with a definite pore diameter and aspect ratio were used as templates tosynthesize polymer pillared layer structures. The pillared polymer was produced in the template membrane pores, and thelayer on the template surfaces. Rigid cured epoxy resin, polystyrene and soft hydrogel were chosen to confirm themethodology. The pillars were in the form of either tubes or fibers, which were controlled by the alumina membrane pore surface wettability. The structural features were confirmed by scanning electron microscopy results.     

Simultaneous Determination of Copper and Bismuth by Anodic Stripping Voltammetry Using H‐Point Standard Addition Method with Simultaneous Addition of Analytes

Simultaneous determination of bismuth and copper by anodic stripping voltammetry using H‐point standard addition method (HPSAM) with simultaneous addition of analytes is described. The effect of various parameters including acid concentration, accumulation time, accumulation potential and concentration ratio of analytes in the standard solution on the sensitivity and accuracy of method were investigated. The results of applying the H‐point standard addition method showed that Cu²⁺ and Bi³⁺ could be determined simultaneously with the concentration ratios of Cu²⁺ to Bi³⁺ varying from 1 : 15 to 16 : 1 in the mixed sample. The method was successfully applied to the simultaneous determination of copper and bismuth in some synthetic mixtures.     

纳米金标记电化学检测DNA特异性结合蛋白

将单分子发夹寡核苷酸固相延伸形成双链寡核苷酸, 以纳米金颗粒标记NF-κB并银染放大, 采用阳极溶出电位法对NF-κB进行检测. 结果表明, 本法检测序列特异性蛋白质具有高度特异性、高灵敏度和快速等特点, 为转录因子调控机制、开放阅读框识别和功能基因检测等的研究提供了有利工具.     

Manganese detection in marine sediments: anodic vs. cathodic stripping voltammetry

Three different electroanalytical techniques for the detection of manganese in marine sediments are evaluated. The anodic stripping voltammetry of manganese at an in situ bismuth-film-modified boron-doped diamond electrode and cathodic stripping voltammetry at a carbon paste electrode are shown to lack the required sensitivity and reproducibility whereas cathodic stripping voltammetry at a bare boron-doped diamond electrode is shown to be reliable and selective with a limit of detection, from applying a 60 s accumulation period of 7.4 × 10⁻⁷ M and a sensitivity of 0.24 A M⁻¹. The method was used to evaluate the manganese content of marine sediments taken from Šibenik, Croatia.     

Electrocatalytic oxidation and detection of hydrazine at gold electrode modified with iron phthalocyanine complex linked to mercaptopyridine self-assembled monolayer

Electrocatalytic oxidation and detection of hydrazine in pH 7.0 conditions were studied by using gold electrode modified with self-assembled monolayer (SAM) films of iron phthalocyanine (FePc) complex axially ligated to a preformed 4-mercaptopyridine SAMs. The anodic oxidation of hydrazine in neutral pH conditions with FePc-linked-mercaptopyridine-SAM-modified gold electrode occurred at low overpotential (0.35 V versus Ag|AgCl) and the treatment of the voltammetric data showed that it was a pure diffusion-controlled reaction with the involvement of one electron in the rate-determining step. The mechanism for the interaction of hydrazine with the FePc-SAM is proposed to involve the Fe^(III)Pc/Fe^(II)Pc redox process. Using cyclic voltammetry (CV) and Osteryoung square wave voltammetry (OSWV), hydrazine was detected over a linear concentration range of 1.3 × 10⁻⁵ to 9.2 × 10⁻⁵ mol/L with low limits of detection (ca. 5 and 11 μM for OSWV and CV, respectively). At concentrations higher than 1.2 × 10⁻⁴ mol/L the anodic peak potential shifted to 0.40 V (versus Ag|AgCl), and this was interpreted to be due to kinetic limitations resulting from the saturation of hydrazine and its oxidation products onto the redox-active monolayer film. This type of metallophthalocyanine-SAM-based electrode is a highly promising electrochemical sensor given its ease of fabrication, good catalytic activity, stability, sensitivity and simplicity.